by David Wilcock

Dr. John DeSalvo of the Giza Pyramid Research Association brought the pyramid research of Joe Parr to the world’s attention through media appearances on the Laura Lee Show and Jeff Rense Show. Joe Parr holds a law degree and also has over 40 years experience as an electronics engineer. Parr’s interest in pyramid research first came about from his meeting George Van Tassel, an early contactee, in the 1950s, who informed him about the “pyramid power” experiments of Pat Flanagan that had demonstrated the sharpening of razor blades in the pyramid structure. Other experiments showed that organic materials would naturally dehydrate without putrefying while inside a pyramidal structure. Even raw, unrefrigerated milk would keep from spoiling if properly positioned.

STATIONARY PYRAMID RESEARCH

Parr went on to begin studying pyramid-related phenomena, first by simply using stationary pyramids and taking measurements from them. These pyramids could be made of nothing more than four horizontal rods forming a base and four vertical rods forming the edges. He would then place sources of radio waves, magnetic fields, ion sources and radioactive sources inside the pyramids, and measure their strength outside the pyramids. From this study, he found that a spherical energy field surrounds any pyramid structure. The exact center of this orb corresponds to the Queen’s Chamber position in the Great Pyramid of Giza. Inside this “orb,” the strength of the electromagnetic or radioactive source that he placed inside will still be measured at its full potential, but areas outside the orb will have a 1 to 3 percent reduction in the amount of measurable energy.

VARIANCE WITH SOLAR, LUNAR AND OTHER CYCLES

After 13 years of studying this phenomenon, Parr found that a negative ion generator (air ionizer) would strengthen the orb, causing it to shield and hold in even more energy than before. Specific sound frequencies such as 51.5 hertz could also be used to strengthen the orb. Over the course of 20 years of measurements, Parr determined that the strength of this energy orb varies with the common 11-year sunspot cycle, and the width of the orb expands and contracts with the phases of the moon. All of these observations again suggest that the spherical orb is a static torsion field that gathers around the pyramid, and is strengthened by absorbing dynamic torsion fields. These fields can be strengthened by the electrostatic energy in the ions or in the acoustic vibration of air, which also is a vibration of the aether. Solar and lunar activity also has a direct impact on the strength of dynamic torsion energy streaming into the earth.

IMPORTANCE OF “PHI” CYCLE OF TIME

Further analysis determined that the classic “phi” ratio was very important to these energy fields as well, again showing a clear connection to torsion fields. Parr found that a form of “virtual” clock would begin counting at the time that the pyramid was first set in a certain position. This means that once the pyramid was placed in a fixed spot, the orb surrounding the pyramid would gradually become stronger and stronger in its ability to contain the energy fields inside, and the rate of growth for the energy bubble was directly proportional to “phi”. At certain mathematically-defined points in this “phi” cycle, the bubble will expand and contract in size, outside of the effect caused by the moon. This suggests a slow, long-term harmonic “wobble” in the energy field, reverberating like a gong in synchrony with the phi-proportions of the in-streaming torsion waves.

ENERGY FROM GALACTIC CENTER

Parr’s experiments were abruptly disturbed on December 4, 1979, when the spherical energy orbs around the pyramids started rapidly disappearing on all but one experiment for an unknown reason. This caused the electromagnetic and radioactive sources inside the pyramids to suddenly flow without interruption into the surrounding space. Years later, Parr was very surprised to find out that the stream of X-rays from the center of our galaxy had abruptly shut off that day, and the anomaly was widely noted by astronomers.

Other pyramid-energy shutdown events documented by Parr also corresponded precisely with drop-offs in our galaxy’s X-ray emissions, though he was unaware of this connection at the time the measurements were made. This is another valuable piece of data, as it shows us that the center of the galaxy is actually our primary source of in-streaming torsion wave energy. In this case, the torsion waves appear to be propagating in tandem with the X-ray wavelengths of the electromagnetic energy spectrum. Even though the activity of the Sun can increase or decrease the strength of torsion waves coming into the Earth, without the input from the Galactic Center we will have much less energy available to us.

About nine days after Dec. 4, 1979, the spherical energy fields started to return, yet all but one pyramid had lost the original energy strength of the orb, which had slowly accumulated over time according to the “virtual clock” of the phi radio. The only pyramid that did not lose its energy field throughout this entire time period was a pyramid that was rotating by a mere 5 degrees every 10 days. As Parr allowed this particular experiment to continue running, he found that the strength of its energetic orb continued increasing, eventually surpassing all of his other stationary pyramids. As we now know, the slight rotation caused the pyramid to absorb a small but measurable amount of torsion waves that would otherwise be traveling straight down and/or straight up with the gravitational field.

IMPORTANCE OF ROTATION IN ENERGY-SHIELDING EFFECT

So, only the rotating pyramid survived the galaxy-induced “blackout” of December 4, 1979, and somehow the rotation caused it to eventually harness more energy than all the others. This was Parr’s first realization that rotating the pyramids could dramatically enhance the strength of energy that they were absorbing and radiating, as Russian scientists such as Kozyrev had already discovered. For several years he tinkered with various designs to rotate pyramids, and he also found out that he could strengthen their energy fields even further by passing them through alternating magnetic fields as they rotated. This allowed him to reach levels much higher than the 1 to 3 percent shielding for a stationary pyramid. As he reached these higher levels, he also noticed that there would be a reduction in the weight of objects inside the pyramid as well; gravity was also being shielded.

“PINCH-OFF” AND HYPERSPACE

Over this time, he calculated that when he could get the pyramids to reach a certain speed while also bathing the surrounding air with atomic particles such as ions, there would be a “pinch-off” where the shielding would reach 100 percent. At this point the pyramid’s energy field would completely shield off all electromagnetic, radioactive and gravitational energy. Rotation alone could create a 50% shielding effect when the proper speed was attained, and the atomic particles were required to reach the 100% pinch-off point. Sunlight could also be used as the source of atomic particles to achieve complete shielding in the energy orb.

Obviously, this fits in with our previously stated ideas about objects displacing into higher levels of aetheric density, drawing from the concepts of Dr. Vladimir Ginzburg, Dr. A.M. Mishin and Dr. Harold Aspden. Indeed, it appears that an object will gradually displace into a higher aetheric density as it vibrates closer to the speed of light. Eventually, a complete shift can be made into the higher density at that point, and when the pressure is later released, the object will naturally shift back down into our own density. This also correlates with the patent of David Hudson, where micro cluster iridium was seen to disappear when it was heated up to 850° Celsius, but would reappear when the temperature was reduced.

Therefore, it shouldn’t surprise us that once the 100% shielding level was attained in Parr’s experiments, the pyramid would temporarily disappear from our known “three-space” reality. At these times, the pyramids would disconnect from their epoxy mountings on the rotating arm, which was calculated to require 2,000 pounds of force, or a sudden increase in kinetic (movement) energy that was 113,000 times greater than before. In 55 different experiments of this type, the pyramid would pass through solid objects such as the wall of the machine, which formed an enclosed shell that surrounded the path of the pyramid’s rotation. When the pyramid would reemerge into our own space after passing through the solid casing of the machine, it would be traveling at a tremendous speed like a bullet and often end up embedding itself into the wall of his laboratory or exploding.

SETUP OF EXPERIMENT

Now that we have established that this very anomalous effect would occur, it is good for us to have a better understanding of how this machine was actually constructed. In Parr’s setup, a 5-inch thick, 3-foot diameter circular chamber houses a blade that rotates in a propeller-like fashion. The wood blade is 3 inches wide by 1/8-inch thick and swings in a 25-inch diameter circle. At both ends of the arm, two small one-inch base pyramids weighing eight grams each and made of ABS plastic are attached. The points of the pyramid are horizontally aligned with the base, pointing away from the center of the arm. The centrifuge is driven by a 12-volt DC ¼ horsepower motor in the 700-2400 rpm range. As the pyramids rotate, they pass through 36 pairs of magnets arranged in a giant circle, each pair attached just over one inch above and below the path of the pyramids on the ends of the rotating arm. The magnetic pairs alternate between north and south polarity, causing a continuing fluctuation in the fields that the pyramids were exposed to.

As we said, Parr determined that under sufficiently energetic conditions, the interior of the 1-inch wide plastic pyramids would start to shield all known energy fields, whether gravitational, electromagnetic or radioactive. The area inside the bubble surrounding the pyramids would lose weight. Radioactive materials, radio frequency sources and magnetic sources placed inside the small pyramids would be shielded from the outside. When pinch-off is achieved, the pyramids would either self-destruct or travel through solid objects, as indicated. This would also have the effect of causing extensive damage to the rotating arm and the entire inside of the machine.

ENERGY STREAM BETWEEN SUN AND ORION’S BELT

Parr found that this sudden increase of energy leading to pinch-off would occur most reliably every year on Dec. 13-16, and his measurements were taken over a 13-year period. Eventually, Parr discovered that at this time, the Earth’s orbital path was intersecting an imaginary line that could be drawn between the Sun and the belt stars of Orion. This led Parr to conclude that an active energy conduit of some sort exists between the Sun and the stars of Orion’s belt. This also falls in line with our expectations related to torsion fields, as there will be streams of aetheric energy connecting all the stars together and flowing between them. The closer we are to a star, the stronger the stream will be, and in the case of Orion’s belt we have three central stars in close proximity with four other close stars surrounding them in a giant “X” shape. Thus, the shape of the stars in the Orion constellation forms a passive torsion generator in its own right.

ACCELERATION TO AND FROM THE MOON

One of the most interesting findings of Joe Parr comes from his observations of which direction the pyramids would travel in once they achieved pinch-off. Under the following experimental conditions, we should assume that the moon is new, meaning that it is not giving off light. Parr found that if the rotating chamber for the pyramid was bathed with negative ions, it would accelerate away from the moon. However, if the chamber was filled with positive ions, the pyramid would accelerate towards the moon. This fits in line with our quantum physics models, where in this case we would see the Earth as if it were a giant atom. A pyramid that is displaced into a higher aetheric density with negative ions will move towards the center of the earth, just as the negatively-charged electron clouds will press towards the center of the atom. Similarly, a pyramid charged with positive ions will accelerate away from the center of the earth, repelling against the negative charge.

STAN TENEN’S DISCOVERY OF GIZA PYRAMID AS A RESONATOR

In a 2000 appearance on the Laura Lee Show, researcher Stan Tenen noted that the Great Pyramid of Giza is built in harmony with the molecular structure of its materials. The vast majority of blocks that make up the pyramid are limestone, which is primarily a calcium carbonate [CaCO3] crystal. The Great Pyramid was built with a 51 degree, 51 minute slope angle, and Tenen pointed out that the calcium carbonate molecule has an approximately 52-degree angle in its shape. This is known as a “cleavage angle” and means that when pure calcium carbonate crystals are split, they will tend to split along this 52-degree angle. Therefore, Tenen claims, the slope angle of the pyramid brings its entire shape into harmony with the molecules of the matter that makes it up. Tenen knows of no other structure on Earth that fits this pattern. Clearly, such a harmonic connection between “micro” and “macro” would only further enhance the pyramid’s effects.

More On Pyramid Power by David Wilcock:

Excerpt from The Divine Cosmos

See Part I here.